Rancilio Classe 10 RE Manuel d'utilisateur télécharger pdf (Page 8)

Once dispensing has ended, the following comes up

on display:

- OK (if the dispensing time is comprised in ± 15%

of the time stored)

- Deviation time in seconds (if the dispensing

time is out of the ± 15% tolerance)

In both of these functions, the display shows pro-

gressive cup ll-up based on the impulses being

dispensed.

5.2.1.4 Enable programming

To enable or disable the dose programming function

in auto-tuning mode (User Manual par. 9.1.1).

5.2.1.5 International settings

Setting the following measure units:

- Temperature [Celsius or Fahrenheit]

- Pressure [bar or psi]

- Resin unit [French degrees/litres or Grains/

Grains Gallons]

5.2.1.6 Strength reduction

Enabling this function will reduce the boiler resistance

strength by 2/3 of its rated capacity.

6000W 230V => 4000W 230V

4300W 230V => 2870W 230V

3200W 120V => 2130W 120V

5.2.1.7 Regeneration of the lter resins

Toenablethelterresinsregenerationmessage,itis

necessary to set the water mains hardness and the

water treatment unit’s resins volume.

If the volume is set at 0, the function is disabled.

5.2.1.8 Preventive maintenance

To enable the programmed maintenance message on

display, it is necessary to set the number of relative

cycles (i.e. dispensing cycles) or the relative months

of machine operation.

The reset function serves to deactivate the mainte-

nance message so that it is not displayed.

5.2.1.9 Boiler sensor

Setting the type of boiler pressure sensor:

- Temperature sensor

- Pressure transducer (default)

5.2.1.10 Level sensor

Sets the type of boiler water level sensor:

- Level indicator rod

- Capacitive board (default)

5.2.1.11 Error codes log

Display of the machine error logs (ref. par. 9). Displays

the error code, with relative date and time.

5.2.1.12 First-time start up

Setting,atcoffeemachinerst-timestartup,ofthe

machine’scongurationmenu(ref.par.4).Anyrst-

time start up data set previously, remain stored into

the system.

5.2.1.13 Technical menu access block

Provides the option of blocking access to the technical

menu via password “1927”.

5.2.1.14 Software versions

Displays the software versions installed into the

machine.

5.2.2 Counters

5.2.2.1 Brew count

By enabling the output counting, the counter would

account for the coffees output by multiplying by 2 the

output started with the 2-coffee keys, and counting

also the interrupted outputs.

The 5

key onto the coffee keyboards does not start

any output continuously, but it works as Stop only.

By disabling the counting, any single key is accounted

for, and the 5

key operates as Start/Stop only.

5.2.2.2 Selection counter

This displays the counters for each coffee group, the

water group, the iSteam group and the total of the

counters. It also asks you whether you wish to reset

the counters or not. Even if you reset these counters,

the totals continue to increase.

BREW COUNT

SELECTIONS COUNTER

COUNTERS

GENERAL COUNTER

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Rancilio Classe 10 RE Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Rancilio Classe 10 RE